There are no products listed under this category.
- SELECT VEHICLE
- TECH INFO
- HOW TO CHECK WHEEL CLEARANCE
- HOW TO MEASURE A ROTOR OFFSET
Shop by Brand
CCB Break-in Procedure
RB CCB Bed-in Procedure
Carbon Ceramic rotors, unlike iron rotors, require longer bed-in time before developing an optimal performance. Less bed-in or over bed-in will affect the braking performance.
Please proceed with the following steps:
Initial Bed-In: (System warm up & engage rotors and pads together as one unit)
- Speed: Gentle stops from 50mph (80kmh) down to 20mph (32kmh)
- Pedal strength: ≤50%
- Repetition: 20 times
Heavy Bed-In: (Friction layer formed between rotors and pads)
- Speed: Heavy stops from 90mph (145kmh) down to 75mph (120kmh)
- Gradually Increase Pedal strength: 30%→50%→80%
- Repetition: 10 times
Cool off Bed-In: (System cool down)
- Speed: Stop from 50mph (80kmh) down to 20mph (32kmh)
- Maintain Pedal strength: ≤50%
- Repetition: 20 times
When you finish all above steps, the rotor surface should look shinny which is an indication that the bed-in procedure is successfully completed. If not due to variable setups and road conditions, repeat the above steps.